SONY DSCP2 Repair Manual

DSC-P2
2-13.BARRIER UNIT
5 Ornamental fixed plate (A)
1 Switch on a power supply.6 Two screws
2 Push zoom button and transform the lens(M1.4 � 4.5)
as shown below.
3 Switch off a power supply by taking out a battery7 Barrier unit
or cut off a power supply from AC daptor.
(without using camera?s power swich)
A
4 Pinch A portion with finger
and fit a driver over a hollow.
[BARRIER OPERATION TEST METHOD]
After the barrier unit is replaced, check the following items with turning the power of the set ON/OFF.
The lens moves out and the barrier shutters open completely when the power is turned on.
The lens moves in and the barrier shutters close completely when the power is turned off.
Checking condition is 1 downward 2 45° downward 3 horizontal 4 45° upward 5 upward; totally five positions
and check three times for each position.
1 downward2 45° downward3 horizontal4 45° upward5 upward
The test needs to be performed only when the barrier unit is replaced.
No performance of this test is needed when the lens is replaced.
2-9