Preparation of Flange Back Adj.[Automatic Adjustment Program execution items and
(Using the minipattern box)sequence]
1) The minipattern box is installed as shown in the f1. Data Setting during Camerollowing fig-a Adj.
ure.2. Flange Back Adj.
Note:The attachment lenses are not used.3. Release of Data Setting during Camera Adj.
2) Install the minipattern box so that the distance between it and
the front of lens of camera is less than 3 cm.
3) Make the height of minipattern box and the camera equal.[Adjusting method]
4) Check the output voltage of the regulated pow1)er supply is theIf the [Start] button of the CAMERA Adjustment 1 is clicked,
specified voltage ? 0.01 Vdc.the following message is displayed.
5) Check that the center of Siemens star chart meets the center ofIf OWide Limit Adjustment� is necessar[Cancel]y, click the
shot image screen with the zoom lens at TELE end and button to interrWIDEupt the Adjustment Program, and perform O1.
end respectively.W ide Limit Adjustment�.
Specified voltage: The specified voltage varies according to the
minipattern box, so adjustment the power sup-
ply output voltage to the specified voltage writ-
ten on the sheet which is supplied with the mini-
pattern box.
Below 3 cm
Minipattern box
CameraFig. 6-1-20
2) If the [OK] button is clicked, the Automatic Adjustment Pro-
gram executes O1. Data Setting during Camera Adj.�.
3) Upon successful completion of the O1. Data Setting during
Regulated power supply
Output voltage : Specified v? 0.01 oltage VdcCamera Adj.�, the following message is displayed. Set the sub-
Output current : more than 3.5 Aject by referring to OPreparation of Flange Back Adj.�.
Red (+)
Black (�)
Yellow (SENS +)
White (SENS �)Need not connected
Fig. 6-1-21
Black (GND)
Fig. 6-1-184) If the [OK] button is clicked, O2. Flange Back Adj.� and O3.
Release of Data Setting during Camera Adj.� will be executed.
Preparation of Flange Back Adj.5) Upon successful completion of all items of the CAMERA
(Using the flange back adjustment jig)Adjustment 1, the following message is displayed. Click the
(Luminance: about 300 lux)[OK] button.
1) Install the flange back adjustment jig so that the distance be-
tween it and the front of lens of camera is less than 3 cm.
2) Make the height of flange back adjustment jig and the camera
equal.
3) Check that the center of chart meets the center of shot image
screen with the zoom lens at TELE end and WIDE end respec-
tively.
Below 3 cm
Flange back adjustment jigFig. 6-1-22
Camera
Fig. 6-1-19
DSC-M2_ADJ
6-19 |
ACEC
