DSR-70/70P
Installation
Caution
Fitting Procedure
If this option is installed incorrectly, personal injury or
damage to peripheral items may occur due to fire, shock,1Remove the DSR-70/70P bottom panel (four screws).
or other accidental circumstances. To avoid such risks,Follow the steps shown in the figure to remove the bottom
installation should be performed by qualified servicepanel (because there are switch and knob on the front
personnel.panel).
Preparations
Before installing the board into the VCR, first connect the two1Bottom panel
ribbon cables to the PP-55 board. (Take care not to insert the
cable upside down.)3
The ribbon cable connectors are equipped with locks. Make2
sure the connectors are unlocked before inserting the ribbon
cable, and close the locks after the ribbon cables are inserted.
UnlockedLocked
(Continued)
Insert the cables so that the end panels are facing upward.
1-99
1011 |