http://getMANUAL.com
DSR-70/70P
Selecting an Edit ModeFinding Edit Points NSearch
Playback in search mode using the jog and shuttle dials allows finding edit
Insert Editing
points quickly.
Jog mode
In insert editing, you insert video, audio, and timecode at desired positions
Playback speed is determined by the rotation speed of the jog dial between
on an already recorded tape. You can insert all three types of data at the?1 times normal speed. Rotate the dial in the clockwise direction to search
same time, or insert one of the types separately.
in the forward direction, and rotate the dial in the counterclockwise
direction to search in the reverse direction.
Note
Before you use an unrecorded tape in insert editing, video signal such as
Shuttle mode
black signal and timecode must be recorded on all over the tape.
Playback speed is determined by the rotation angle of the shuttle dial
between ?32 times normal speed (21 steps). Click points allow playback
Selecting insert modeat ?5 times normal speed.
Rotate the dial in the clockwise direction to search in the forward
direction, and rotate the dial in the counterclockwise direction to search in
the reverse direction.
Chapter 3EditingChapter 3Editing
Switching between each mode
RECORDER
Lighting the JOG or SHUTTLE indicator shows the corresponding mode
is selected.
1Switching from jog to shuttle mode
Rotate the shuttle dial.
INSERT
VIDEOAUDIOTCSwitching from shuttle to jog mode
2Press the jog dial or rotate the jog dial while setting the shuttle dial at still
CH1,1/2CH2,3/4position.
1Press the RECORDER button on the recorder control panel.To switch between normal playback and search modes
The RECORDER indicator lights.Press the PLAY and search buttons alternately.
2Press one or more of the INSERT buttons on the recorder control panelAs factory default setting, rotating the jog or shuttle dial switches to search
to select the signals you want to insert.mode at any time except during recording and editing.
If you change the setting of setup menu item 101, the above function will
The corresponding INSERT indicators light.be disabled and switching to search mode will be possible only when the
search button is pressed.
To cancel insert mode
Press the lit INSERT buttons again to turn the corresponding indicatorsFor details about setting, see item 101 on page 106.
off. Selection of a signal is canceled when its indicator goes out.
1-25
48Chapter 3 EditingChapter 3 Editing49 |
ACEC
