3-2. Replacement of Main Parts
3-2. Replacement of Main Parts2. Power supply unit
1. Drive fan pack(1) Remove the drive fan pack. (Refer to Sec. 3-2. 1.
Drive fan pack.)
(1) Hold the four knobs by the fingers on the drive fan(2) Turn off the power and disconnect the AC cord.
pack as shown in the figure by arrows, remove the(3) Unlock the lever in arrow direction on the figure,
drive fan pack toward in front shown by arrow.remove the power supply unit toward in front.
Drive Fan PackPower Supply
nn
. When replacement of the drive fan pack, it can removing. When replacing the power supply unit, confirm the
and reassembling just as remaining ON the power of theDMW-S01NL system was stopped.
DMW-ST001.
. When drive fan pack was removed, cooling check indicatorAdjustment after replacing the power supply unit
of power supply unit will blinking.When replacement the power supply unit, setting or
When leave the drive fan pack was removed more thanadjustment etc., are not required.
two minutes, power supply of HDD is turned off. (But,
power supply of the DMW-ST001 is hold ON.) WhenPower Supply : EMC Parts No. DAEPS
reassemble the drive fan pack, power supply of HDD is
return to ON.
Drive Fan Pack : EMC Parts No. SFAN
3-2DMW-S01NL/S02NL/ST001 |
ACEC
