1-6. Tape Drive Replacement
1-6. Tape Drive Replacement1-6-1. DTF Tape Drive
NotePreparation
wTurn off the main power of the console.
1. Replace the tape drive following the specified(Refer to Section 1-1-2.)
procedure.
The DTF tape drive (GY series) weighs about 20 kg.
Replacement Procedure
If it is not replaced according to the specified proce-
dure, the tape drive may fall and cause serious injury.1. Disconnect the cables connected to the tape drive to be
. Replace a tape drive with two or more persons.replaced.
. Follow the rack mounting procedure described in the2. Draw the drive stage to the front.
following sections.(1) Loosen the two fixing screws.
2. Do not install the tape drive GY-2120 and GY-(2) Hold the handle and draw the drive stage out to the front
until the lock levers of the right/left rails are locked.
8240/DIR-240 together.
To maintain an appropriate operating environment, the
tape drive GY-2120 and GY-8240/DIR-240 cannot be
installed together.
nLock lever
Fixing screw
. This document uses GY-8240 as an example of the DTF
tape drive for explanation.
. When the extension console is connected or under some
installation conditions of the basic console, the stage
panel may hinder the top and bottom drive stages on the
Handle
right of the basic console from disengaging depending
on the angle of the opened stage panel when the drive
stages are pulled out. Therefore, pull out the drive stageLock lever
while removing the stage panel while referring toDrive stage
Section 1-3. ORemoving the External Cabinets�.
3. Take the tape drive down from the drive stage.
(1) While raising the rear panel side of the tape drive with
your hands, take the tape drive down from the drive
stage by drawing the tape drive to the front.
Tape drive
Drive stage
(2) Turn off the main power of the tape drive.
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S1-25 |
ACEC
