DCR-TRV75/TRV75E/TRV80/TRV80E
11. Color Reproduction Adjustment
Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
SubjectColor bar chart
(Color reproduction adjustment frame)
Measurement Point ideo terminal of VAUDIO/VIDEO jack
Measuring Instrument Vectorscope
Adjustment PageF
Adjustment Address37, 39, 40, 41
Specified Value All color luminance points should settle
within each color reproduction frame.
For NTSC model
Note1: The data of page: 0, address: 10 must be O00�.
Note2: NTSC model: DCR-TRV75/TRV80
PAL model: DCR- TRV75E/TRV80E
Switch setting:
1) POWER.................................................................. CAMERA
2) NIGHT SHOT ..................................................................OFF
3) FOCUS.................................................................. MANUAL
4) DIGITAL ZOOM (Menu setting) ....................................OFF
5) STEADY SHOT (Menu setting) ......................................OFF
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 6, address: 9D, and set data: 20.
3) Select page: 6, address: 01, set data: 3D, and press the PAUSEBurst position
button.
4) Select page: F, address: F0, set the following data, and press
the PAUSE button.
37 (NTSC), B7 (PAL)
5) Adjust the GAIN and PHASE of the vectorscope, and adjustFor PAL model
the burst luminance point to the burst position of the color
reproduction frame.Burst position
6) Change the data of page: F, address: 37, 39, 40 and 41, and
settle each color luminance point in each color reproduction
frame.
Note:Be sure to press the PAUSE button of the adjustment remote
commander before changing the addresses. If not, the new data
will not be written to the memory.
Processing after Completing Adjustments:
1) Select page: 6, address: 01, set data: 00, and press the PAUSE
button.
2) Select page: 6, address: 9D, and set data: 00.
3) Select page: 0, address: 01, and set data: 00.
Fig. 6-1-14.
6-28 |
ACEC
