DCR-TRV345E/TRV350/TRV351/TRV355E/TRV356E
12. Angular Velocity Sensor Output Check and
Steadyshot CheckRadarWRadarWRadarWRadarWRadarW
Check the angular velocity sensor output.
Precautions on the Parts Replacement
There are two types of repair parts.
Type AENC03JA
Type BENC03JB
Replace the broken sensor with a same type sensor. If replace with
other type parts, the image will vibrate up and down or left and
right during hand-shake correction operations.
Precautions on Angular Velocity Sensor
The sensor incorporates a precision oscillator. Handle it with care
as if it dropped, the balance of the oscillator will be disrupted and
operations will not be performed properly.
ModeCAMERA
SubjectNot required
Measurement PointDisplayed data of page: 1 (Note 2)
Measuring Instrument Adjusting remote commander
Specified valuePITCH data: 2B00 to 4B00
YAW data: 2B00 to 4B00
Note 1:Check that the data of page: 0, address: 10 is O00�.
Note 2:The right four digits of the page: 1 displayed data of the
adjusting remote commander.
1:XX:XX
Displayed data
Switch setting:
1) ZOOM .....................................................................TELE end
2) STEADYSHOT (Menu setting)........................................ ON
Checking method:
Order Page Address DataProcedure
PITCH sensor output check (SE751 of SI-036 board)
100311
W ith the set in still state,
check that the displayed data
21
(Note 2) satisfies the PITCH
data specified value.
YAW sensor output check (SE752 of SI-036 board)
300312
W ith the set in still state,
41check that the displayed data
(Note 2) satisfies the YAW
data specified value.
500300
Steady shot operation check
Shake the set vertically and
horizontally to check that the
6steady shot function operates
normally.
6-31 |
ACEC
