DCR-TRV145E/TRV147E/TRV245E/TRV250E
1-5. SELF-DIAGNOSIS FUNCTION
1-5-1. Self-diagnosis Function1-5-2. Self-diagnosis Display
When problems occur while the unit is operating, the self-diagnosisWhen problems occur while the unit is operating, the counter of the
function starts working, and displays on the vieviewfwfinder or LCDinder or LCD shows a 4-digit display consisting of an alphabet
what to do. This function consists of two display; self-diagnosisand numbers, which blinks at 3.2 Hz. This 5-character display
display and service mode display.indicates the Orepaired by:�, Oblock� in which the problem occurred,
Details of the self-diagnosis functions are provided in the Instrand Odetailed code� of the problem.uction
manual.
Viewfinder or LCD
C : 3 1 : 1 1
Blinks at 3.2Hz
C3 1 1 1
Repaired by:BlockDetailed Code
C : Corrected by customerIndicates the appropriateRefer to O1-5-4. Self-diagnosis Code Table�.
H : Corrected by dealerstep to be taken.
E : Corrected by serviceE.g.
engineer31....Reload the tape.
32....Turn on power again.
1-5-3. Service Mode Display
The service mode display shows up to six self-diagnosis codes shown in the past.
1.Display Method
While pressing the OSTOP� key, set the switch from OFF to OVCR or PLAYER�, and continue pressing the OSTOP� key for 5 seconds
continuously. The service mode will be displayed, and the counter will show the backup No. and the 5-codes.haracter self-diagnosis c
Viewfinder or LCD
[3] C : 3 1 : 1 1
Lights up
[3] C : 3 1 : 1 1
Backup No.Self-diagnosis CodesControl dial
Order of previous errors
2.Switching of Backup No.
By rotating the control dial, past self-diagnosis codes will be shown in order. The bac which thekup No. in the [] indicates the order in
problem occurred. (If the number of problems which occurred is less than 6, only the number of problems wshown.)hich occurred will be
[1] : Occurred first time[3] : Occurred third time[5] : Occurred fifth time
[2] : Occurred second time [4] : Occurred fourth time[6] : Occurred the last time
3.End of Display
Turning OFF the power supply will end the service mode display.
Note:The Oself-diagnosis display� data will be backed up by the lithium battery (CONTROL SWITCH BLOCK (CF-3000):
BT001). When removing the cabinet (R) (removing the VC-304 board CN1007), the Oself-diagnosis display� data will
be lost by initialization.
1-3 |
ACEC
