1-9. ERROR3. Adjustment Time Out
In case of an error during the execution of adjustment, the Auto-
matic Adjustment Program interrupts the processing at that point,
and displays an error message, and then terminates the program
execution there.This part indicates
the adjustment
1-9-1. Error Messageitem in which
an error occurred.
W hen an error message is displayed, perform the remedy given
below, and then retry adjustment. If the error message is displayed
though the remedy was performed, the circuits will be faulty.Fig. 6-1-19
1. Connect ErrorSymptomAdjustment does not finish within the specified
time.
Cause? Adjustment conditions are wrong.
? Data error exists in the camera.
Remedy? Check that the conditions such as a subject
are correct.
? Reset the camera.
4. Adjustment NG
Fig. 6-1-17
SymptomUSB communication with the set is abnormal.
Cause? USB cable is not inserted tightly.
This part indicates
? Power supply is not installed correctly.the adjustment
? Communication with SeusCam is abnormal.
item in which
Remedy? Disconnect the USB cable once, and then re-an error occurred.
connect it tightly and check that the set is in
OUSB Mode�.Fig. 6-1-20
? Install the power supply correctly.
? Start the SeusCam and click the [Connect] toSymptomThe adjusted data does not become the speci-
fied value.
check that the connection state is established.
Cause? Adjustment conditions are wrong.
? Data error exists in the camera.
2. RESET the CAMERA and Try AgainRemedy? Check that the conditions such as a subject
are correct.
? Reset the camera.
Fig. 6-1-18
SymptomThe camera is not ready for adjustment.
Cause? Data error exists in the camera.
Remedy? Reset the camera.
DCR-DVD202E/DVD203/DVD203E/DVD703/DVD703E
6-42 |
ACEC
