Customizing Your Monitor
Automatically Adjusting theEliminating Flickering or Blurring
PictureManually
If the picture is flickering or fuzzy, press the AUTO button.If a part of the screen is flickering or blurring, press the
The monitor is automatically adjusted to match the signalAUTO button. If this operation does not work, adjust the
from the connected computer.Pitch and Phase as follows.
Further fine adjustments may be needed with someOnce the pitch and phase are adjusted, they will be stored in
computers. In this case, manually adjust the monitor.memory for the current input signal.
1Turn on the monitor.1Set the resolution to 1280 ´ 1024 on the computer.
If the resolution of the graphics board is lower than 1280
2Turn on the computer.´ 1024, set ZOOM to REAL (page 12).
3Press the AUTO button.2Load the Utility Disk.
The monitor adjusts the pitch to match the input signalUse the appropriate disk for your computer.
so that the picture appears sharp, and fits the picture toFor Windows 95/98
the center of the screen.Windows Monitor Information Disk/Utility Disk
For Macintosh
AUTOMacintosh Utility Disk
3Start the Utility Disk and display the test pattern.
For Windows 95/98
Click [Utility Disk] n [Windows] n [Utility.exe].
For Macintosh
Click [Utility Disk] n [SONY-Utility].
4Press the MENU button.
NotesThe MENU OSD appears.
Y This function is intended for use with a computer running
MENUOKMENU
Windows or similar graphic user interface software thatMENU
provides a full-screen picture. It may not work properly if theEXIT
background color is dark or if the input picture does not fill thePHASE
PITCH
screen to the edges (such as an MS-DOS prompt).
CENTER
Y The screen may go blank for a few seconds while performing theZOOM/SMOOTHING
auto-sizing function. This is not a malfunction.COLOR
LANGUAGE
OPTION
If the picture is flickering or fuzzy even after you
press the AUTO button
Adjust the Pitch and Phase by referring to OEliminating5Press the u/3 buttons to select PITCH, and press the
Flickering or Blurring Manually.�MENU button again.
The PITCH OSD appears.
If the picture is not in the center of the screen
MENU PITCH
even after you press the AUTO button
Adjust using the CENTER OSD by referring to OAdjusting
the Picture Position.� 0
10 |
ACEC
