CPD-G500
Power saving function
This monitor meets the power-saving guidelines set by VESA,
ENERGY STAR, and NUTEK. If the monitor is connected to a
computer or video graphics board that is DPMS (Display Power
Management Signaling) compliant, the monitor will automatically
reduce power consumption in three stages as sho.wn below
Power mode Power consumption 1 (power)
indicator
normal L 145 Wgreen
operation
1 standbyL 100 Wgreen and orange
alternate
2 suspendL 15 Wgreen and orange
(sleep)*alternate
3 active off**Approx. 1 Worange
(deep sleep)*
power off0 Woff
* OSleep� and Odeep sleep� are power saving modes defined by the
Environmental Protection Agency.
** When your computer enters a power saving mode, the input signal is
cut and NO INPUT SIGNAL appears on the screen. After a few
seconds, the monitor enters a power saving mode.
DIAGNOSIS
This monitor is equipped with a self-diagnosis function. If there is If all four color bars appear (white, red, green, blue), the monitor
a problem with your monitor or computer(s), the screen will go is working properly. Reconnect the video input cables and check
blank and the 1 (power) indicator will either light up green or the condition of your computer(s).
flash orange. If the 1 (power) indicator is lit in orange, the
computer is in power saving mode. Try pressing any key on the If the color bars do not appear, there is a potential monitor failure.
keyboard.Inform your authorized Sony dealer of the monitorOs condition.
MENUIf the 1 (power) indicator is flashing orangeRESETINPUTHD15BNC
Press the 1 (power) button twice to turn the monitor off
and then on.
1 (power) indicatorIf the 1 (power) indicator lights up green, the monitor is working
properly.
If the 1 (power) indicator is green
If the 1 (power) indicator is still flashing, there is a potential
monitor failure. Count the number of seconds between orange
1Remove any plugs from the video input 1 and 2
connectors, or turn off the connected computer(s).flashes of the 1 (power) indicator and inform your authorized
Sony dealer of the monitorOs condition. Be sure to note the model
name and serial number of your monitor. Also note the make and
2Press the 1 (power) button twice to turn the monitor model of your computer and video board.
off and then on.
3Move the control button , for 2 seconds before the
monitor enters power saving mode.
MENU
� 3 � |
ACEC
