CPD-E220/E215E/E220E
POWER SAVING FUNCTION
This monitor meets the power-saving guidelines set by *OSleep� and VESA, Odeep sleep� are power saving modes defined by the
ENERGY STAR, and NUTEK. If the monitor is connected to a Environmental Protection Agency.
computer or video graphics board that is DPMS (Display Po**When your computer is in a power wer saving mode, MONITOR IS IN
Management Signaling) compliant, the monitor will automatically POWER SAVE MODE appears on the screen if you press any button
on the monitor. After a few seconds, the monitor enters the power
reduce power consumption in three stages as sho.wn below
saving mode again.
Power mode Power consumption 1 (power)
indicator
normal d 120 Wgreen
operation
1 standbyd 15 Wgreen and orange
alternate
2 suspendd 15 Wgreen and orange
(sleep)*alternate
3 active off**d 3 Worange
(deep sleep)*
power off0 Woff
DIAGNOSIS
This monitor is equipped with a self-diagnosis function. If there is If all four color bars appear (white, red, green, blue), the monitor
a problem with your monitor or computer, the screen will go blank is working properly. Reconnect the video input cable and check
and the 1 (power) indicator will either light up green or flash the condition of your computer.
orange. If the 1 (power) indicator is lit in orange, the computer is
in power saving mode. Try pressing any key on the kIf the color bars do not appeareyboard., there is a potential monitor failure.
Inform your authorized Sony dealer of the monitorOs condition.
MENU
RESET
If the 1 (power) indicator is flashing orange
Press the 1 (power) button twice to turn the monitor off
1 (power) indicatorand then on.
If the 1 (power) indicator lights up green, the monitor is working
properly.
If the 1 (power) indicator is green
If the 1 (power) indicator is still flashing, there is a potential
1Disconnect the video input cable or turn off the
monitor failure. Count the number of seconds between orange
connected computer.
flashes of the 1 (power) indicator and inform your authorized
Sony dealer of the Os monitorcondition. Be sure to note the model
2Press the 1 (power) button twice to turn the monitor
name and serial number of your monitor. Also note the make and
off and then on.
model of your computer and video board.
3Move the control button , for 2 seconds before the
monitor enters power saving mode.
MENU
� 3 � |
ACEC
