The operating instructions mentioned here are partial abstracts
SECTION 1from the Operating Instruction Manual. The page numbers of
the Operating Instruction Manual remein as in the manual.
GENERAL
Use of the tilt-swivel
PrecautionsIdentifying parts and controls
This monitor can be adjusted within the angles shown below. To
find the center of the monitorOs turning radius, align the center of
Warning on power connectionsthe monitorOs screen with the centering dots on the stand.See the pages in parentheses for further details.
Y Use the supplied power cord. If you use a different power cord, Hold the monitor at the bottom with both hands when you turn it FrontRear
be sure that it is compatible with your local power supply.horizontally or vertically. Be careful not to pinch your fingers at
Y Before disconnecting the power cord, wait at least 30 seconds the back of the monitor when you tilt the monitor up vertically.
after turning off the power to allow the static electricity on the
screenOs surface to discharge.MENU
Y After the power is turned on, the screen is demagnetized RESETAC IN
(degaussed) for about 5 seconds. This generates a strong 90u
magnetic field around the screen which may affect data stored 15u
on magnetic tapes and disks placed near the monitor. Be sure to MENU
keep magnetic recording equipment, tapes, and disks away 90uRESET
from the monitor.5u
The equipment should be installed near an easily accessible
outlet.
Centering dots
Installation
Do not install the monitor in the following places:
Y on surfaces (rugs, blankets, etc.) or near materials (curtains,
1RESET button (page 12)4AC IN connector (page 6)
draperies, etc.) that may block the ventilation holes
This button resets the adjustments to the factory settings.This connector provides AC power to the monitor.
Y near heat sources such as radiators or air ducts, or in a place
subject to direct sunlight
2Control button (page 9)5Video input connector (HD15) (page 6)
Y in a place subject to severe temperature changes
1-1Y in a place subject to mechanical vibration or shockThe control button is used to display the menu and make This connector inputs RGB video signals (0.700 Vp-p,
adjustments to the monitor, including brightness and contrast positive) and sync signals.
Y on an unstable surface
adjustments.
Y near equipment which generates magnetism, such as a US
1 2 3 4 5
transformer or high voltage power lines
31 (power) switch and indicator (pages 7, 13, 16)6 7 89 10
Y near or on an electrically charged metal surface
This button turns the monitor on and off. The power indicator 11 12 13 14 15
lights up in green when the monitor is turned on, and either
Maintenance
flashes in green and orange, or lights up in orange when the
Y Clean the screen with a soft cloth. If you use a glass cleaning monitor is in power saving mode.
liquid, do not use any type of cleaner containing an anti-static Pin No.Signal
solution or similar additive as this may scratch the screenOs 1Red
coating.
2Green
Y Do not rub, touch, or tap the surface of the screen with sharp or (Sync on Green)
abrasive items such as a ballpoint pen or screwdriver. This type
of contact may result in a scratched picture tube.3Blue
Y Clean the cabinet, panel and controls with a soft cloth lightly 4ID (Ground)
moistened with a mild detergent solution. Do not use any type
5DDC Ground*
of abrasive pad, scouring powder or solvent, such as alcohol or
benzene.6Red Ground
7Green Ground
Transportation
8Blue Ground
When you transport this monitor for repair or shipment, use the
original carton and packing materials.9�
10Ground
11ID (Ground)
12Bi-Directional Data (SDA)*
13H. Sync
14V. Sync
15Data Clock (SCL)*
* DDC (Display Data Channel) is a standard of VESA.
45 |
ACEC
