CPD-520GS/520GST/520GST9
POWER SAVING FUNCTION
This monitor meets the power-saving guidelines set by VESANote
and ENERGY STAR, as well as the more stringent NUTEK .If no video signal is input to the monitor, the ONO INPUT SIG-
If the monitor is connected to a computer or video graphicsNAL� message (page 1-9) appears. After the delay time has
board that is VESA DPMS (Display Power Management Signal-passed, the power saving function automatically puts the moni-
ing) compliant, the monitor will automatically reduce powertor into the active-off mode and the indicator lights up orange.
consumption in three stages as shown below.Once the horizontal and vertical sync signals are detected, the
You can set the delay time before the monitor enters the powermonitor automatically resumes its normal operation mode.
saving mode using the OSD. Set the time according to OSetting
the power saving delay time� on page 1-7.
Power consumptionScreenHorizontalVerticalPower consumptionRecovery timeu indicator
modesync signalsync signal
1Normal operationactivepresentpresentL 160 WNGreen
2Standby (1st mode)blankabsentpresentL 100 WApprox. 3 sec.Green and orange
alternate
3Suspend (2nd mode)blankpresentabsentL 15 WApprox. 3 sec.Green and orange
alternate
4Active-off (3rd mode)blankabsentabsentL 5 WApprox. 10 sec.Orange
5Power-offNNN0 WNOff
DIAGNOSIS
FailrePower LED
+B failureOrange ?Off
(0.5 sec)(0.5 sec)
Horizontal / Vertical DeflectionOrange ?Off
failure, Thermal protector(1.5 sec)(0.5 sec)
ABL protectorOrange ?Off
(0.5 sec)(1.5 sec)
HV failureOrange ?Off?Orange ?Off
(0.25 sec) (0.25 sec)(0.25 sec)(1.25 sec)
Aging / Self TestOrange ?Off?Green ?Off
(0.5 sec)(0.5 sec)(0.5 sec)(0.5 sec)
Aging Mode (Video Aging) : During Power Save, press OMENU� key for longer than 2 second.
Self Test (OSD Color Bar) : During Power Save, press OCONTRAST� + (/) key for longer than 2 second.
Reliability Check Mode: During Power Save, press OCONTRAST� � (?) key for longer than 2 second.
� 3 � |
ACEC
