p To enter new timings
When using a video mode that is not one of the 10 factory preset modes, someDamper wire
fine tuning may be required to optimize the display to your preferences. Simply
Using a white background, very thin horizontal lines on the screen are visible asadjust the display according to the adjustment instructions. The adjustments will
shown below. These lines are the damper wires.
be stored automatically and recalled whenever that mode is used.
The Trinitron tube has a vertically striped Aperture Grille inside. The Aperture
A total of 10 user-defined modes can be stored in memory. If an 11th mode isGrille allows more light to pass through to the screen giving the Trinitron CRT
entered, it will replace the first.
more color and brightness.
The damper wires are attached to the Aperture Grille to prevent vibration of the
Aperture Grille wire so that the screen image is constantly stable.
Using the tilt-swivel
With the tilt-swivel, this unit can be adjusted to be viewed at your desired angle
within 90! horizontally and 7! vertically.Approx. 6 cm (2 3/8 inches)
To turn the unit vertically and horizontally, hold it at its bottom with both hands.(CPD-220AS only)
Pay attention not to get your hands caught between the display and the tilt-
swivel.
Damper wires
Approx. 6 cm (2
3/8 inches)
45u
7u
45u
14GBUsing Your DisplayUsing Your Display15GB
Adjustments
When one of the preset-type signals is input, no picture adjustment is necessary.The VOLUME/CONTRAST OSD disappears 3 seconds after you release the
You can, however, adjust the picture to your preference by following thebuttons.
procedure described below.
. Tips
To adjust the display, turn on the display and computer.Y The default setting of the volume level is 30 %.
Select the adjustment item. You can adjust all items via the OSD (On ScreenY Adjust the volume while listening to the sound.
Display).Y Excessively high volume may cause howling.
Adjustments are automatically stored in the displayOs memory.
p To mute the sound
Control PanelPress the U button. UThe indicator lights. The light indicates mute function is
in active mode.
Press again to cancel muting.
You can cancel muting also by pressing the . + button.
. Tip
Adjusting volumeU appears instead of . on the VOLUME/CONTRAST OSD while the sound is muted.
1.Press the . + or � button.
The VOLUME/CONTRAST OSD appears.
The horizontal and vertical frequencies for each input signal received
appear.Adjusting the picture contrast
The adjustment data becomes the common setting for all input signals.
1.Press the > + or � button.
The VOLUME/CONTRAST OSD appears.
The horizontal and vertical frequencies for each input signal received
appear.
HorizontalVertical
frequencyfrequency
2.Press the . +/� buttons to adjust volume.
+ to increase volume
� to decrease volume
Continued to the ne�xt page
16GBAdjustmentsAdjustments17GB
� 7 � |
ACEC
