Step 3: Presetting radio stationsTo change the AM tuning
(continued)interval (except for the European
model)
To stop scanning
The AM tuning interval is factory-set to 9 kHz
Press TUNING MODE.
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
To tune in a station with a weak
the system. While holding down the TAPE x
signal
button, turn the system back on. When you change
Press TUNING MODE repeatedly until OAUTO�the interval, all the AM preset stations are erased.
and OPRESET� disappear from the display inTo reset the interval, repeat the same procedure.
step 2, then press TUNING + or � repeatedly to
tune in the station manually.Tips
Y The preset stations are retained for about a day even
To set another station to theif you disconnect the power cord or if a power
exist preset numberfailure occurs.
Y You can label the preset stations (see page 63).
Start over from step 1. After step 5, press . or
Y When an FM stereo program has static noise, press
> on the remote to select the preset number on
STEREO/MONO until OMONO� scrolls in the
which you want to store the station.display. There will be no stereo effect, but the
reception will improve. Press the button again to
To erase a preset stationrestore the stereo effect.
1 Press MENU/NO on the remote.
2 Press . or > repeatedly until OP.Erase ?�
appears.
Select OP.All Erase ?� when you want to erase
all the preset stations.
3 Press ENTER/YES on the remote.
4 Press . or > repeatedly to select the
preset number you want to erase.
5 Press ENTER/YES.
OComplete !!� appears.
When you erase a preset number, the preset
number decreases by one and all preset numbers
following the erased one are renumbered.
8 |
ACEC
