CDX-R5715X/R5810/R6750
General
CAUTION
OutputsAudio outputs terminal (front/rear)
Subwoofer output terminal (mono)Use of controls or adjustments or performance of procedures
Power antenna relay control terminalother than those specified herein may result in hazardous
Power amplifier control terminal
radiation exposure.
InputsTelephone ATT control terminal
Illumination control terminal
BUS control input terminal
If the optical pick-up block is defective, please replace the whole
BUS audio input/AUX IN terminal
Remote controller input terminaloptical pick-up block.
Antenna input terminalNever turn the semi-fixed resistor located at the side of optical
Tone controlsCDX-R5715X:
pick-up block.
Bass: ?10 dB at 62 Hz
Treble:? 10 dB at 16 kHz
CDX-R5810/R6750:
Bass: ?8 dB at 100 Hz
optical pick-up
Treble:? 8 dB at 10 kHz
Loudness+8 dB at 100 Hz
+2 dB at 10 kHz
Power requirements12 V DC car battery
(negative ground)
DimensionsApprox. 178 � 50 � 182 mm
(7 1/8 � 2 � 7 1/4 in.) (w/h/d)
Mounting dimensionsApprox. 182 � 53 � 161 mm
(7 1/4 � 2 1/8 � 6 3/8 in.) (w/h/d)
MassApprox. 1.2 kg
(2 lb. 10 oz.)
Supplied accessoriesParts for installation and connections (1 set)
Front panel case (1)
Card remote commander RM-X153 (CDX-R5715X)
Card remote commander RM-X157 (CDX-R5810)
Card remote commander RM-X155 (CDX-R6750)
US and foreign patents licensed from Dolby Laboratories.
Note
This unit cannot be connected to a digital preamplifier or an equalizer which is Sony
BUS system compatible.semi-fixed resistor
Design and specifications are subject to change without
notice.
Y CDX-R5810/R6750 model
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generaThis label is located on the bottom of the chassis.ted by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECKSAFETY-RELATED COMPONENT WARNING!!
The laser beam on this model is concentrated so as to be focused on
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
the disc reflective surface by the objective lens in the optical pick-
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
up block. Therefore, when checking the laser diode emission, ob-
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
serve from more than 30 cm away from the objective lens.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PA RT NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
Notes on Chip Component ReplacementIN SUPPLEMENTS PUBLISHED BY SONY.
YNever reuse a disconnected chip component.
Y Notice that the minus side of a tantalum capacitor may be
damaged by heat.ATTENTION AU COMPOSANT AYANT RAPPORT
� LA S?CURIT?!!
TEST DISCS
This set can playback CD-R and CD-ROM discs. The folloLES COMPOSANTS IDENTIFI?S PwingAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCH?MATIQUES ET LA LISTE DES PIéCES SONT
test discs should be used to check the capability:
CRITIQUES POUR LA S?CURIT? DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIéCES SONY
CD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
DONT LES NUM?ROS SONT DONN?S DANS CE MANUEL OU
CD-RW test disc TCD-W082L (Part No. J-2502-063-2)DANS LES SUPPL?MENTS PUBLI?S PAR SONY.
2 |
ACEC
