CDX-F5700/F5705X
InputsTelephone ATT control terminal
Illumination control terminalCAUTION
BUS control input terminalUse of controls or adjustments or performance of procedures
BUS audio input or AUX IN terminal
other than those specified herein may result in hazardousRemote controller input terminal
radiation exposure.
Antenna input terminal
Tone controlsUS, Canadian Model:
If the optical pick-up block is defective, please replace the wholeBass ?10 dB at 62 Hz
Treble ?10 dB at 16 kHz
AEP, UK, E Model:optical pick-up block.
Bass ?8 dB at 100 HzNever turn the semi-fixed resistor located at the side of optical
pick-up block.Treble ?8 dB at 10 kHz
Loudness+8 dB at 100 Hz
+2 dB at 10 kHz
Power requirements12 V DC car battery
(negative ground)
DimensionsApprox. 178 � 50 � 181 mmoptical pick-up
(7 1/8 � 2 � 7 in.) (w/h/d)
Mounting dimensionsApprox. 182 � 53 � 161 mm
(7 1/4 � 2 1/8 � 6 3/8 in.) (w/h/d)
MassApprox. 1.2 kg
(2 lb. 10 oz.)
Supplied accessoriesParts for installation and connections (1 set)
Front panel case (1)
Card remote commander RM-X114
Note
This unit cannot be connected to a digital preamplifier or an equalizer which is Sony
BUS system compatible.
Design and specifications are subject to change without
notice.
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
semi-fixed resistor
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
? AEP, UK, E model
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
This label is located on the bottom of the chassis.
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
? Never reuse a disconnected chip component.
? Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
TEST DISCS
This set can playback CD-R and CD-ROM discs. The following
test discs should be used to check the capability:
CD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
CD-RW test disc TCD-W082L (Part No. J-2502-063-2)
ATTENTION AU COMPOSANT AYANT RAPPORT
SAFETY-RELATED COMPONENT WARNING!! � LA S?CURIT?!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINELES COMPOSANTS IDENTIFI?S PAR UNE MARQUE 0 SUR LES
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND INDIAGRAMMES SCH?MATIQUES ET LA LISTE DES PIéCES
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.SONT CRITIQUES POUR LA S?CURIT? DE FONCTIONNEMENT.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSENE REMPLACER CES COMPOSANTS QUE PAR DES PIéCES
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL ORSONY DONT LES NUM?ROS SONT DONN?S DANS CE MANUEL
IN SUPPLEMENTS PUBLISHED BY SONY.OU DANS LES SUPPL?MENTS PUBLI?S PAR SONY.
2 |
ACEC
