1-2-2. key check[DISPLAY BOARD] � Conductor Side �
All buttons are assigned with numbers respectively
CN805
If a button is pressed, the number is counted up and the button
71IN/OUT SW
number is displayed.
6
IC801
GND
Button number display
[SERVO BOARD] � Conductor Side �
Button name Button number display
CN105CN107
+88
RV101
321CN106
=01
)02(ADJ)(GND)
(AFJ)
003
IC107
PLAY áSegment ON 1
PSegment ON 2
pAll ONIC105TP3
IC106
(TEI)
(TE)CN108
1
1-2-3. Remocon check2
3
Press á button on the Remocon, and á �on FL tube turnsO
(VC)
on. If any other buttons are pressed, all tubes will turn off.
1-3. ADJ MODE
With CN105 3 pin connected to 1 pin on the Servo Board, turn
on the POWER switch, and the ADJ mode is activated where the
following operation is executed.
Y GFS, even if low continuously during playing, will cause noth-
ing.
Y High speed servo is disabled during an access.
Y Gain of focus servo and spindle servo is not lowered.
Y Manual operation and measurement for servo system are en-
abled. (For detailed operation method, see the button function
table in ADJ mode.)
1-4. CLV-S MODE
Connect TP1(ADJ) to the GND after turning on the POWER
switch, and the spindle servo becomes CLV-S mode during play-
ing.
Button function table in ADJ mode
With the TIME key, the jitter value display mode is activated
after all music remaining mode.
The number buttons have the functions as listed below.
Functions of number buttons
(on Remocon attached)
ButtonsFunctions
1Increase focus bias by 8 steps
2Adjust focus bias to the center
3Turn off tracking servo and sled servo
4Initialize auto gain
5Turn off focus servo
6Decrease focus bias by 8 steps
7Readjust focus bias there
8Turn on tracking servo and sled servo
10Return auto focus bias to start point
� 4 � |
ACEC
