SECTION 6
ADJUSTMENTS
6-1. MECHANICAL ADJUSTMENTS
Pop Up Mechanism AdjustmentGROUP1
1. With the power ON, while pressing the GRá OUP 4 and
GROUP2
buttons, press the +100 button to enter the mechanism adjust-
ment mode.GROUP4
2. Press the GROUP 1 button to operate the loading mechanism,
and continue pressing until the disc table locks. (Fig-1)
3. Press the GROUP 2 button to raise the pop up part.
4. Remove the cover (chassis), loosen the adjusting screw, move
the screwdriver left and right until the lever (POP UP) does not
touch the slit wall, and secure the screw. (Fig-2)
The following buttons have special functions in this mode.
GROUP 1 button: Loading mechanism IN operation
GROUP 5 button: Loading mechanism OUT operation
GROUP 2 button: Pop up part UP operation
GROUP 6 button: Pop up part DOWN operation
At this position,this
part will be locked.
FIg-1
Cover (chassis)
Lever (pop up)
Fix to the center so that the
lever (POP UP) does not
touch the slit.
FIg-2
� 15 � |
ACEC
