SECTION 5
MECHANICAL ADJUSTMENTS
Perform the following steps before carrying out adjustments.
1. Turn ON the power of the unit, set disc to disc table No. 92,
and perform chucking.
2. Turn OFF the power.
3. Remove the case.
4. While pressing the [STOP] button, turn ON theI/u button.
The test mode is set.
5. TheI/u button LED (STANDBY) starts blinking.
(Test mode)LED (STANDBY)
1/up
1/u buttonSTOP button
Note 1:The cam will start rotating when the [GROUPE1] or [GROUPE5]
button is pressed continuously in the test mode.
GROUP 1
button
GROUP 5
button
GROUP 1 button GROUP 5 button
Note 2:If the power cannot be supplied, the cam can be rotated by rotat-
ing the pulley with your finger.
cam
pulley
� 13 � |
ACEC
