CCD-TRV107E/TRV108E/TRV208E/TRV408E
2. Flange Back AdjustmentRadarWRadarWRadarWRadarWRadarWAdjusting method for 1/4 CCD model:
(Using Minipattern Box)
Order Page Address DataProcedure
The inner focus lens flange back adjustment is carried out
100101Set the data.
automatically. In whichever case, the focus will be deviated during
2F86Write down the data.
auto focusing/manual focusing.
3F8600Set the data and press PAUSE
SubjectSiemens star chart with ND filter for
button.
the minipattern box (Note1)
460113Set the data, and press PAUSE
Measuring Instrument Adjustment remote commander
button.
Adjustment PageF
560127Set the data, and press PAUSE
Adjustment Address46 to 55, 58
button.
Note1: Dark Siemens star chart.6602Check that the data changes to
Note2: Check that the data of page: 6, address: 02 is O00�. If not, to page:O01�. (Note5)
6, address: 01, set data: 00, and press the PAUSE button.
7F86Set the data that is written down
Note3: Make the lens horizontal and perform this adjustment.
at step 2 and press PAUSE button.
Note4: 1/4 CCD model: CCD-TRV408E
1/6 CCD model: CCD-TRV107E/TRV108E/TRV208E
Note5: The adjustment data will be automatically input to page: F, address:
46 to 55, 58.
Switch setting:
NIGHT SHOT (Lens block) ............................................OFF
Adjusting method for 1/6 CCD model:
Order Page Address DataProcedure
Preparations:
1) The minipattern box is installed as shown in the follo10wing0101Set the data.
figure.260113Set the data, and press PAUSE
Note:The attachment lenses are not used.
button.
2) Install the minipattern box so that the distance between it and
360127Set the data, and press PAUSE
the front of the lens of the camcorder is less than 3cm.
button.
3) Make the height of the minipattern box and the camcorder equal.
4) Check that the output voltage of the regulated po4 wer supply is602Check that the data changes to
the specified voltage.O01�. (Note5)
5) Check that at both the zoom lens TELE end and WIDE end,
Note5: The adjustment data will be automatically input to page: F, address:
the center of the Siemens star chart and center of the exposure
46 to 55, 58.
screen coincide.
Processing after Completing Adjustments:
Specified voltage: The specified voltage varies according to the
minipattern box, so adjust the power supplyOrder Page Address DataProcedure
output voltage to the specified volta1ge written60100Set the data, and press PAUSE
on the sheet which is supplied with thebutton.
minipattern box.
200100Set the data.
3Turn off the power and turn on
Below 3 cm
again.
Minipattern box4Perform OFlange Back Check�.
Camcorder
Camera
table
Regulated power supply
Output voltage : Specified v?0.01Vdcoltage
Output current : more than 3.5A
Red (+)
Black (�)
Yellow (SENS +)
White (SENS �)Need not connected
Black (GND)
Fig. 5-1-7.
5-13 |
ACEC
