2. Installation of the Board
2. Installation of the BoardProcedures
This section describes the installation procedures for the1. Turn the SIU-80 power off and remove the front panel
front plug-in board and rear connector panel in a Systemand shield plate.
Interface Unit SIU-80.(Refer to the Installation Manual supplied with SIU-80.)
For more details of each procedure, refer to the applicable2. Set the switches on the board. (Refer to O4-1. Setting
sections and Installation Manual supplied with SIU-80.and function of switches/LEDs on board�.)
3. Insert the board into a slot, and then turn the board
2-1. Plug-in Board Installationlevers in the direction of the arrow 1 and connect the
board securely to the connector of the SIU-80Os mother
board.
Flow for installation
Start
Plug-in board
Slot selection
2
Switch setting on board1
Plug-in board installation
SIU-80
Model label attachment
Board leverBoard lever
End1Install11
2222Remove
General information for installation
4. Install the shield plate.
Y The plug-in board (BKSI-2040) is inserted into any slotThen, attach the model label supplied with the board
No.1 to No.8 in the front of SIU-80.on the right side of the shield plate.
For the number of maximum boards to be installed inThis label position should be aligned with the slot
SIU-80, refer to the Installation Manual supplied withinstalling the board.
SIU-80.5. Install the front panel.
Y The model label supplied with the board is attached to
the shield plate to prevent the board inserting into the
incorrect slot when the board replacement and others.
SIU-80
Model label
Shield plate
PSW 3X6
Front panel
n
When removing the board, pull the board out from the
slot turning the board levers in the direction of the
arrow 2.
BKSI-20401-3 (E) |
ACEC
