2. Information of BKSI-2010
2.Information of BKSI-2010
Flow for installationProcedures
Start1. Turn off the power of the SIU-80 and remove the front
panel and shield plate.
Slot selection(Refer to the Installation Manual supplied with SIU-80.)
2. Insert the board into a slot, and then turn the board
Plug-in board installation : SCS-4 board
levers in the direction of the arrow 1 and connect the
board securely to the connector of the SIU-80Os mother
Model labels attachment
board.
Connector panel installation : IO-116 board
Cable connection
End
2
1
2-1.Plug-in Board Installation
SIU-80
General information for installation
Board leverBoard lever
Y The plug-in board (SCS-4 board) is inserted into any slot111Install
222Remove
No.1 to No.8 in the front of SIU-80.
Y One of the model label supplied with BKSI-2010 is
attached to the shield plate to prevent the board inserting3. Install the shield plate.
into the incorrect slot when the board replacement andThen, attach the model label on the right side of the
others.shield plate.
Y BKSI-2011 (MY-72 board) is used to mount on BKSI-This label position should be aligned with the slot
2010.installing the board.
A maximum of four combinations (BKSI-2010 + BKSI-4. Install the front panel.
2011) can be installed in SIU-80.
Follow the precautions below when install the combina-
tion.
(1) Install the combination to the slot of even number.
(2) For realizing the heat radiation, set a dead slot (of
odd number) on BKSI-2011.
Y In the board replacing, set the setting of the switch
S3301 on a new board to the setting of the removed
SIU-80
board.
Model label
Shield plate
PSW 3´6
Front panel
n
If removing the board, turn the board levers in the direction
of the arrow 2, and remove the board from the slot.
BKSI-20101-3(E) |
ACEC
