3. Information of BKSI-2011
3.Information of BKSI-2011
3-1.Installation to BKSI-20105. Tighten the screws secured temporarily in step 2.
The round hole next to the connector CN1 (MY-72
1. Remove the three screws on the SCS-4 board shown inboard) is used for inserting a screw-driver.
the figure.
SCS-4 boardScrew-driver
PTTWH3 X6
2. Temporarily secure the three brackets supplied withn
BKSI-2011 to the SCS-4 board by the screws removedWhen the BKSI-2011 is installed onto the BKSI-2010, the
in step 1.BKSI-2010 can process up to four-channel playback
nsignals.
Take care of the direction of bracket at installation.If the BKSI-2010 cannot process expanded channel signals
even though the BKSI-2011 is installed, make sure that the
PTTWH3 X6connectors are properly connected.
For the more details of the confirmation, refer to the
Maintenance Manual.
Bracket
3. While inserting the brackets into the hole on the MY-
72 board and matching the position, connect the
connector CN1 on the MY-72 board to the connector
CN2001 on the SCS-4 board.
Insert the connector securely and make sure that
between connectors have no space.
4. Tighten the three screws.
PWH3 X6
CN1 connector
CN2001 connector
MY-72 board
Hole
SCS-4 board
1-10(E)BKSI-2010 |
ACEC
