Section 1
Installation
1-1. Contentsn
Y To remove the connector panel, move the right and left
Contens of BKPF-201ends at the connector panel to the front and back direc-
Y AD-131 Board(1)tions alternately until the connection with the mother
Y Connector (CN-1323 Board) (1)board is sufficiently loose, then pull out the connector
Y Operation Manual(1)panel gently.
Y Maintenance Manual(1)Y To avoid shock hazards, do not open the slot.
Y Slot Labels(1)Y Be sure to attach the blank panel to the dead slot.
1-2. Installation of the BoardsInstallation of the AD-131 board
Y This section is described that the boards are attached to1. Loosen the two screws and remove the front panel.
PFV-D20.
If the boards are attached to the models except PFV-
D20, refer to the manuals packing with the models.
Y The boards can be inserted to your required empty slot of
PFV-D20.
Installation of the connector panel (CN-1323 board)
1. Turn off the power switch of PFV-D20.
2. Remove the two screws and the blank panel of your
Screws (with stoppers)
required slot.
n
If the board fastening brackets are attached to the AD-131
board, remove the board fastening brackets.
2. Insert the AD-131 board to the slot.
n
Insert the AD-131 board in the slot with attaching the
connector panel (CN-1323 board).
Screws (B 3 x 6)
3. Attach the connector panel to the rear panel of PFV-
D20 and secure the connector panel by the two
removed screws.
AD-131 board
Keep the board levers perpendicular
to the front of the board.Component side up
Connector panel Screws (B 3 x 6)
BKPF-2011-1 (E) |
ACEC
