Section 1
Installation
1-1. Contents
Contens of BKPF-132Bn
Y EN-131 Board(1)Y To remove the connector panel, move the right and left
Y Connector (CN-415I Board) (1)ends at the connector panel to the front and back direc-
Y Operation Manual(1)tions alternately until the connection with the mother
Y Maintenance Manual(1)board is sufficiently loose, then pull out the connector
Y Slot Labels(1)panel gently.
Y To avoid shock hazards, do not open the slot.
1-2. Installation of the BoardsBe sure to attach the blank panel to the dead slot.
Y This section is described that the boards are attached toInstallation of the EN-131 board
PFV-D20.
If the boards are attached to the models except PFV-1. Loosen the two screws and remove the front panel.
D20, refer to the manuals packing with the models.
Y The boards can be inserted to your required empty slot of
PFV-D20.
Installation of the connector panel (CN-415I board)
1. Turn off the power switch of PFV-D20.
2. Remove the two screws and the blank panel of your
required slot.
Screws (with stoppers)
n
If the board fastening brackets are attached to this unit,
remove the board fastening brackets.
2. Insert the EN-131 board to the slot.
n
Insert the EN-131 board in the slot with attaching the
Screws (B 3´6)
connector panel (CN-415I board).
3. Attach the connector panel to the rear panel of PFV-
D20 and secure the connector panel by the two
removed screws.
EN-131 board
Keep the board levers perpendicular
Component side up
to the front of the board.
Connector panel
Screws (B 3´6)
(CN-415I board)
BKPF-132B1-1 (E) |