3-3. Video Signal System
5. The Return Matrix setup display appears.3-3-7. Setting the DUAL CAMERA MODE
The present allocated Return numbers are shown in
high light in the selection line.When AUX IN and AUX OUT on the rear panel of the
nunit are respectively connected to the BNC cable, two
The Return number to be allocated can be changed inCAMERA systems can be operated by using one fiber
this state.cable. In this case, set the CCU connected by using the
fiber cable to Dual Mode: Primary and the CCU connected
All the signals that can be allocated, are listed and theby using the BNC cable to Dual Mode: Secondary.
list of signal names is shown in the center box. SelectPerform this setting on the setup menu of the unit or on the
the desired signal to be allocated using the MSU-configuration menu of the MSU-700A/750.
700A/750 knob, and press [Enter].n
nThe AUX MATRIX setting of the CCU that is set to
The present allocated signals are high lighted onPrimary or Secondary is fixed to AUX and cannot be
display.changed. In addition, AUX1/2/3 cannot be switched from
the CA-950/950P. The Primary CCU and Secondary CCU
Return SettingExit
must be synchronized.
SelectIf setting the BVP-9500WS/9500WSP at the primary side
?
to the three-time speed when the dual system is operated
Return1SDI IN1Enter
SDI IN2
by the BVP-9500WS/9500WSP, the primary mode is
SDI IN3
Return2SDI IN4Cancelreleased. In this case, the secondary system is not transmit-
SDI AUX
Return3InputCamerated.
Analog IN1
The BVP-9500WS/9500WSP at the secondary side cannot
Return4
be set to the three-time speed.
Correspondence between the signal names in the box andSetting on the setup menu of the unit
the actual signals is shown as follows.
Rotary encoder
Name inActual selection signalNORMMIC LEVELNORMMENUINCOMPGMSIDE
RTSCANCEL
POWERMINOFFONMINSELECTMIXTONE
the selection boxCH-1CH-2ENTERCANCEL ENGPRIVPRODATE
ENGPROD
SDI IN1CCU rear panel SERIAL RET INPUT1MENU ON/OFF switch
SDI IN2CCU rear panel SERIAL RET INPUT2
AT-122 board
SDI IN3CCU rear panel SERIAL RET INPUT3
1. Set the MENU ON/OFF switch on the AT-122 board
SDI IN4CCU rear panel SERIAL RET INPUT4
panel to ON. The setup menu will be displayed.
SDI AUXCCU rear panel SERIAL AUX IN
2. Select OOthers� from the setup menu entry display.
CAMERACAMERA picture
Analog IN1CCU rear panel RET INPUT1
* Setup Menu *
Analog IN2CCU rear panel RET INPUT2 Return
AUX
Analog IN3CCU rear panel RET INPUT3
PROMPT
Analog IN4CCU rear panel RET INPUT4 PIX Out
WFM Out
PROMPTERCCU rear panel PROMPTER IN
ColorBars
>Others
CCU-900/900P IMM3-11 (E) |
ACEC
