Open both the appliance door and that of the kitchen
unit to approx. 90°.
Place the little plates over the runners. Hold the doors
of the appliance and the unit together and mark the
holes.
Fig. 10
8mm
PR34
Remove the little plates and make the holes with a di-
am. of 2 mm. Replace the little plates over the runners
and screw in the screws provided (3.5x16 mm).
For the alignment of the kitchen unit door, if neces-
sary, use the clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Fig. 11
PR35
If the appliance is Ţxed to the side of the kitchen unit,
simply slacken the screws in Ţxing brackets (F), move
the brackets as shown in the Ţgure and re-tighten the
screws.
Then Ţt cover (G).
Fig. 12
F
G
D295
9 |
ACEC
TRICITY BENDIX
