6BBBBlllluuuueeeessss DDDDeeeeVVVViiiilllllllleeee AAAAmmmmpppplllliiiiffffiiiieeeerrrr
¨
Your new Blues DeVille amplifier delivers world�classY Performance tested and matched GT6L6B Fender
¨¨
Fendertone and world�standard Fenderquality:Groove Tubesa
Y Two-button footswitch (included) enables remote
Y 60 watts output into 4& or 8&
channel selection and Reverb on-off switching
Y All tube preamp and power amp provide harmonically
Y Multi-function Preamp out / Power amp in jacks
rich distortion and touch-sensitive dynamics
Y External speaker jack allows optional speaker arrays
Y Selectable channels offer sparkling-clean and high-
gain tones fueled by three 12AX7 preamp tubes¨¨
Thank you for choosing FenderThank you for choosing Fender
NTNTone, Tone, Tradition and InnovationNsince 1946radition and InnovationNsince 1946
TTTToooopppp PPPPaaaannnneeeellll
A. INPUT 1 - Plug in connection for most guitars.L. PREAMP OUT / POWER AMP IN -
(1) Effects Loop- Connect PREAMP OUT to your effects
B. INPUT 2 - A lower sensitivity (-6dB) than INPUT 1, offering
input, and POWER AMP IN to the effects output.
cleaner response with high-output instruments or a darker
tone with Opassive� instruments. If both inputs are used(2) Multiple Amps - Connect PREAMP OUT on the
simultaneously, both input sensitivities become identical.primary unit to POWER AMP IN on the auxiliary unit. The
primary unit is used to control the auxiliary unit, except for
C. CHANNEL SELECT - Press to switch channels:
Reverb and Presence which remain active on each unit.
NormalNuse the VOLUME {E} control
(3) Recording or Reinforcement - Connect PREAMP
DriveNuse DRIVE {F} and MASTER {G} controls
OUT to the input of sound equipment.
D. CHANNEL INDICATOR - Use shielded instrument cables with PREAMP
OffJJNormal channel is activeOUT and POWER AMP IN. Both jacks are located before
RedNJJ O Drive channel is activeReverb and Presence in the signal path.
E. VOLUME - Adjusts the loudness of the Normal channel.M. FOOTSWITCH - Connect the included footswitch to
enable remote Channel and Reverb switching. When
F. DRIVE - Adjusts the preamp volume and distortion level
connected, the footswitch overrides the corresponding
of the Drive channel.
panel controls. NOTE: Use unshielded speaker cable
G. MASTER - A final adjustment for the overall loudness ofrather than instrument cable for connecting the
the Drive channel. After you set the DRIVE {F} level, usefootswitch.
MASTER to normalize the Drive channel volume.
N. POWER INDICATOR - Illuminates when the Blues DeVille
H. NORMAL/BRIGHT - Boosts high-frequency response.is on. Unscrew the red jeweled cover to access the bulb
(type T47) for replacement.
NormalBright (boost)
O. STANDBY - Switch into Standby instead of turning the
I. MIDDLE/BASS/TREBLE - Adjusts the mid/low/high
power off during short breaks to keep the tubes warm and
frequency tone characteristics, respectively.
ready to play; switch into Standby before turning the
J. PRESENCE - Adjusts ultra-high tone characteristics afterpower on N and stay in Standby for 30 seconds after the
the preamp distortion stage, producing a special high-power is on. These procedures will extend the life of your
frequency sparkle.amplifier tubes.
K. REVERB - Adjusts the Reverb effect level.P. POWER SWITCH - Turns the Blues DeVille on-off.
'ff ee nn dd ee rr .. cc oo mm ' |
ACEC
FENDER
